McLelland AVD-800P Guia de Configuração descarregar pdf (Página 6)

8 ZONES AUDIO/ VIDEO MULTI-ROOM/

SOURCES DISTRIBUTION AMPLIFIER

AVD-800P

Figure 5: ADDRESS/AGC DIP Switch Setting

The AVD-800P DIP switch show the 7 Pin through Check selection, the 1-5 are Address Select, Pin 6

is the front panel broadcast function selection and when the Pin 6 is at "1" position , this unit show the

broadcast to the zone which has powered on, when Pin 6 is at "0" position, if used broadcast, the unit will

cut all the zone and show the broadcast through these although the zone at the Standby position, it will

be also cut to broadcase.

Pin7 = AGC Select,

0 = AGC Enable,

1 = AGC Disable.

For Example: If Master = DIP SW 12345 switch to the "0" position, Slave 1 = DIP SW 1234 switch to the

"0" position, SW 5 switch to the "1" position.

Note: All the modication of the DIP Switch ( including AGC ) must be action after the restart of the AVD-

800P

Figure 4: IR Emitters Connections

There is Eight IR emitters are supplied with your AVD-800P System, which can be IR Commands for the

source equipment are transferred from the AVD-800P amplier to the source equipment using the mini

IR emitters. Just plugged into the corresponding source IR output on the AVD-800P and then placed

over the IR receiver window on the source component. Compatible with most brands of remote controls,

though some may not be programmable and will therefore only control the source components.

EX: If Master = DIP SW 12345 switch to the "0" position, Slave 1 = DIP SW 1234 switch to the "0" posi-

tion, SW 5 switch to the "1" position.

Note: All the modication of the DIP Switch ( including AGC ) must be action after the restart of the AVD-

800P

1 2 3 4 5 6 7 8 9

Sem comentários

McLelland AVD-800P Guia de Configuração Página 6